A practical reference on creatinine: what it is, how it behaves, what the literature reports, and where the honest uncertainties sit.
This page was last updated on 2026-08-01 and is reviewed periodically as new material appears.
Dry creatine monohydrate is generally stable when kept sealed and protected from heat and moisture. In solution, however, creatine undergoes a slow cyclization to creatinine, a related compound with no role in phosphocreatine storage. The rate of this conversion increases with temperature and is influenced by pH. Because creatinine is a common impurity in liquid or poorly stored products, analytical testing often measures both compounds. The crystalline monohydrate is less prone to degradation than aqueous preparations, though caking can occur if moisture enters the container.
Laboratory analysis of creatine monohydrate typically uses high-performance liquid chromatography to separate creatine from creatinine and other impurities. Detection may be ultraviolet, refractive index, or mass spectrometric, depending on the laboratory's equipment and the required sensitivity. Nuclear magnetic resonance spectroscopy can quantify the main component and identify related substances. Water content is measured by Karl Fischer titration, which is important because the monohydrate has a defined theoretical hydration level. Heavy metals, residual solvents, and microbial limits are also checked in quality control programs.
The compound was identified in the nineteenth century after chemists isolated a nitrogenous substance from meat extracts. Later work established its role in muscle energy metabolism and its conversion to phosphocreatine. Chemical synthesis of creatine followed, and industrial production made the monohydrate widely available as a purified powder. Interest expanded in the late twentieth century when researchers began studying creatine supplementation and muscle physiology. Historical accounts sometimes differ on exact dates and attributions, but the broad sequence from tissue extracts to synthetic production is well documented.
In the body, creatine is obtained from dietary meat and fish and is also synthesized from arginine, glycine, and methionine. Muscle stores creatine and phosphocreatine, which participate in the rapid regeneration of adenosine triphosphate during short, intense activity. The monohydrate form is used in research because it is chemically defined, stable as a dry solid, and relatively inexpensive to produce. Questions remain about whether other creatine forms offer meaningful advantages in absorption or tissue retention, and findings vary across studies and populations.
| Property | Value | Notes |
|---|---|---|
| Typical storage temperature | 15–25 °C | Protect from moisture, heat, and direct sunlight |
| Analytical method | HPLC with UV or RI detection | Separates creatine from creatinine and related impurities |
| Water content | About 12.1% w/w | Theoretical value for the monohydrate crystal |
| Degradation product | Creatinine | Formed by cyclization, especially in aqueous solution |
| Common assay specification | 98.0–102.0% | Range depends on the testing method and monograph |
Regulatory status varies by country. In the United States, creatine monohydrate is sold as a dietary supplement ingredient, while in the European Union it is placed on the market as a food supplement component. Some jurisdictions have established purity monographs or permitted health claims, while others treat it as a novel food or require notification. Product labels may state the amount of creatine monohydrate or the equivalent creatine content, and the two figures can differ. Independent testing programs sometimes check identity, potency, and contaminant limits.
Creatine monohydrate is stable under dry, cool conditions but can degrade when exposed to moisture and heat. In solution, it undergoes hydrolysis to creatinine, a cyclic derivative with little role in phosphagen energy transfer. The rate of conversion increases with temperature, storage time, and acidic or alkaline pH. Solid material kept in a sealed container at room temperature generally retains its composition for extended periods. Moisture uptake is a primary concern because it can accelerate breakdown and caking.
Analytical laboratories commonly use high-performance liquid chromatography to separate creatine from creatinine and related impurities. Ion chromatography, nuclear magnetic resonance, and titration assays can also quantify the compound. Water content is measured by Karl Fischer titration or loss on drying, because the monohydrate has a defined theoretical water fraction. Particle size, bulk density, and flowability are physical properties that affect blending and capsule filling. These measurements support quality control and help verify that a lot matches its specification.
Storage recommendations generally emphasize a cool, dry place away from direct sunlight and strong oxidizers. Sealed containers limit humidity exchange, which helps prevent clumping and gradual conversion to creatinine. Long-term stability studies usually monitor appearance, moisture, and purity at intervals under defined temperature and humidity conditions. Accelerated tests at elevated temperature can reveal degradation pathways, but they do not perfectly predict room-temperature shelf life. Questions remain about how much creatinine formation is acceptable in different product categories and how packaging choices affect that rate over time.
Commercial creatine monohydrate is typically manufactured through chemical synthesis, often starting from sarcosine and cyanamide. The resulting material is crystallized, washed, and dried to a specified hydrate content. Finished lots are tested for identity, purity, moisture, and heavy metals before release. Because the compound can cyclize to creatinine under heat or prolonged storage in solution, manufacturers control temperature and humidity during processing. The solid itself is relatively stable when kept dry and sealed, but moisture uptake can cause caking and complicate accurate assay.
As with bacterial classification, identification of bacteria is increasingly using molecular methods, and mass spectroscopy. Most bacteria have not been characterised and there are many species that cannot be grown in the laboratory. Diagnostics using DNA-based tools, such as polymerase chain reaction, are increasingly popular due to their specificity and speed, compared to culture-based methods. These methods also allow the detection and identification of "viable but nonculturable" cells that are metabolically active but non-dividing. The main way to characterize and classify these bacteria is to isolate their DNA from environmental samples and mass-sequence them. This approach has identified thousands, if not millions of candidate species. Based on some estimates, more than 43,000 species of bacteria have been described, but attempts to estimate the true number of bacterial diversity have ranged from 107 to 109 total species—and even these diverse estimates may be off by many orders of magnitude.
At the active site, a substrate binds to an enzyme to induce a chemical reaction. Substrates, transition states, and products can bind to the active site, as well as any competitive inhibitors. For example, in the context of protein function, the binding of calcium to troponin in muscle cells can induce a conformational change in troponin. This allows for tropomyosin to expose the actin-myosin binding site to which the myosin head binds to form a cross-bridge and induce a muscle contraction. In the context of the blood, an example of competitive binding is carbon monoxide which competes with oxygen for the active site on heme. Carbon monoxide's high affinity may outcompete oxygen in the presence of low oxygen concentration. In these circumstances, the binding of carbon monoxide induces a conformation change that discourages heme from binding to oxygen, resulting in carbon monoxide poisoning.
Aspartate transaminase, as with all transaminases, operates via dual substrate recognition; that is, it is able to recognize and selectively bind two amino acids (Asp and Glu) with different side-chains. In either case, the transaminase reaction consists of two similar half-reactions that constitute what is referred to as a ping-pong mechanism. In the first half-reaction, amino acid 1 (e.g., L-Asp) reacts with the enzyme-PLP complex to generate ketoacid 1 (oxaloacetate) and the modified enzyme-PMP. In the second half-reaction, ketoacid 2 (α-ketoglutarate) reacts with enzyme-PMP to produce amino acid 2 (L-Glu), regenerating the original enzyme-PLP in the process. Formation of a racemic product (D-Glu) is very rare. The specific steps for the half-reaction of enzyme-PLP + aspartate ⇌ {\displaystyle \rightleftharpoons } enzyme-PMP + oxaloacetate are as follows (see figure); the other half-reaction (not shown) proceeds in the reverse manner, with α-ketoglutarate as the substrate.
The general detection scheme involves: Pneumatic nebulization of mobile phase from the analytical column forming an aerosol. Aerosol conditioning to remove large droplets. Evaporation of solvent from the droplets to form dried particles. Particle charging using an ion jet formed via corona discharge. Particle selection – an ion trap is used to excess ions and high mobility charged particles. Measurement of the aggregate charge of aerosol particles using a filter/electrometer. The CAD like other aerosol detectors, can only be used with volatile mobile phases. For an analyte to be detected it must be less volatile than the mobile phase. More detailed information on how CAD works can be found on the Charged Aerosol Detection for Liquid Chromatography Resource Center.
Sources: en.wikipedia.org
Patients with Type II diabetes will have elevated glucagon levels during a fast and after eating. These elevated glucagon levels over stimulate the liver to undergo gluconeogenesis, leading to elevated blood glucose levels. Consistently high blood glucose levels can lead to organ damage, neuropathy, blindness, cardiovascular issues and bone and joint problems. It is not entirely clear why glucagon levels are so high in patients with Type II diabetes. One theory is that the alpha cells have become resistant to the inhibitory effects of glucose and insulin and do not respond properly to them. Another theory is that nutrient stimulation of the gastrointestinal tract, thus the secretion of gastric inhibitory polypeptide and Glucagon-like peptide-1, is a very important factor in the elevated secretion of glucagon.
In cancer cells, an increase in Akt signaling correlates with an increase in glucose metabolism, compared to normal cells. Cancer cells favour glycolysis for energy production over mitochondrial oxidative phosphorylation, even when oxygen supply is not limited. This is known as the Warburg effect, or aerobic glycolysis. Akt affects glucose metabolism by increasing translocation of glucose transporters GLUT1 and GLUT4 to the plasma membrane, increasing hexokinase expression and phosphorylating GSK3 which stimulates glycogen synthesis. It also activates glycolysis enzymes indirectly, via HIF transcription factors and phosphorylation of phosphofructokinase-2 (PFK2) which activates phosphofructokinase-1 (PFK1). Protein kinase B PI3K/AKT/mTOR pathway Signal transduction KEGG Pathway: PI3K-Akt signaling pathway CST: PI3K/Akt Signaling Resources
APHL works with public health partners to build the foundation for quality testing, comprehensive standards and integrated public health laboratory systems. One of the initiatives, the Laboratory System Improvement Program, provides individual assessments of public health laboratory systems that include engaging stakeholders for system improvement, performance, implementation of strategies and continual evaluation. APHL also collaborates on the National Laboratory System project to build a public-private network of laboratories nationwide. APHL monitors trends in public health laboratory diagnostics, personnel and infrastructure in order to create quality assurance standards. By using these data points to benchmark individual labs against national norms, APHL is able to home in on key issues and help raise the standard of laboratory systems. Member labs have access to research and survey data online, which enables them to leverage new information quickly to identify promising strategies and practices.
The carbohydrate-insulin model (CIM) posits that obesity is caused by excess consumption of carbohydrate, which then disrupts normal insulin metabolism leading to weight gain and weight-related illnesses. It is contrasted with the mainstream energy balance model (EBM), which holds that obesity is caused by an excess in calorie consumption compared to calorie expenditure. According to the carbohydrate–insulin model, low-carbohydrate diets would be the most effective in causing long-term weight loss. Notable proponents of the carbohydrate–insulin model include Gary Taubes and David Ludwig. The CIM has been tested in mice and humans. Although some experts consider that these studies falsified the CIM, proponents disagree. Available evidence does not support the existence of a long-term advantage in weight loss for low-carbohydrate diets.
Class A (or 1) (Rhodopsin-like) Class B (or 2) (Secretin receptor family) Class C (or 3) (Metabotropic glutamate/pheromone) Class D (or 4) (Fungal mating pheromone receptors) Class E (or 5) (Cyclic AMP receptors) Class F (or 6) (Frizzled/Smoothened) More recently, an alternative classification system called GRAFS (Glutamate, Rhodopsin, Adhesion, Frizzled/Taste2, Secretin) has been proposed for vertebrate GPCRs. They correspond to classical classes C, A, B2, F, and B. An early study based on available DNA sequence suggested that the human genome encodes roughly 750 G protein-coupled receptors, about 350 of which detect hormones, growth factors, and other endogenous ligands. Approximately 150 of the GPCRs found in the human genome have unknown functions. Some web-servers and bioinformatics prediction methods have been used for predicting the classification of GPCRs according to their amino acid sequence alone, by means of the pseudo amino acid composition approach. GPCRs are involved in a wide variety of physiological processes. Some examples of their physiological roles include:
Sources: en.wikipedia.org
Purity testing often uses high-performance liquid chromatography to measure creatine and creatinine. Water content can be checked by Karl Fischer titration. Additional tests may cover heavy metals, residual solvents, and microbial contamination.
In solution, creatine can cyclize spontaneously to creatinine. Heat and certain pH conditions increase the rate of this conversion. Dry crystalline material is more stable because the reaction requires water.
Typical storage is in a sealed container at room temperature, away from moisture and direct heat. These conditions reduce caking and slow degradation. Liquid products require more careful handling because creatine is less stable in water.
It is a crystalline form of creatine that contains one water molecule per creatine molecule. The compound occurs naturally in muscle tissue and is also produced synthetically for research and consumer products. The monohydrate label describes the solid's hydration state.