The short version of Shelf life fits in a sentence. The long version — which is the one that helps — is below.
This page was last updated on 2025-08-29 and is reviewed periodically as new material appears.
In dry solid form, creatine monohydrate is relatively stable when protected from moisture and heat. The crystal lattice includes water, and exposure to high humidity can cause caking or gradual changes in powder flow. Elevated temperatures may accelerate decomposition, particularly if moisture is present. Studies generally report that sealed, dry material retains acceptable purity for extended periods, although exact shelf life depends on packaging and storage conditions. Light exposure is not usually considered a major factor for this compound.
In aqueous solution, creatine monohydrate undergoes a slow conversion to creatinine, a cyclized degradation product. This reaction is pH- and temperature-dependent, and it proceeds faster in warm or alkaline conditions. Because the conversion is gradual, analytical measurements of creatine in solution must account for time and storage history. The equilibrium favors creatinine more strongly at higher temperatures, which is relevant to sample handling in laboratories and to beverage formulations. Refrigeration slows but does not entirely stop this process.
Quality assessment of creatine monohydrate typically uses high-performance liquid chromatography to separate creatine from creatinine and other impurities. Other methods include nuclear magnetic resonance spectroscopy, titration, and infrared spectroscopy for identity confirmation. Purity is often reported as a percentage of the labeled compound on a dry basis, while moisture content is measured separately. Because different analytical methods have different selectivity, comparing purity values across sources requires attention to the method and sample preparation.
In the body, creatine is synthesized from arginine, glycine, and methionine, mainly in the liver and kidneys, and is also obtained from foods such as meat and fish. About 95% of body creatine is stored in skeletal muscle, where a fraction is phosphorylated to phosphocreatine. Phosphocreatine serves as a rapid reserve of high-energy phosphate for short bursts of ATP regeneration. The monohydrate form supplies creatine after dissolution and absorption, but it is not itself the active phosphorylated species.
Creatine was first identified in skeletal muscle extracts in the nineteenth century, and its role in phosphagen energy buffering was clarified in the twentieth century. The monohydrate salt became widely studied after methods for inexpensive synthesis and crystallization were developed. Modern research examines its effects on muscle energetics, recovery, and cognitive performance under specific conditions. Findings vary with population, exercise protocol, baseline creatine status, and measurement method. Studies often compare supplementation with placebo during controlled training or testing schedules.
| Property | Value | Notes |
|---|---|---|
| Typical storage temperature | 15–25 °C | Cool, dry, sealed container; avoid heat |
| Relative humidity | Low; keep below about 60% | Moisture promotes caking and degradation |
| Primary degradation product | Creatinine | Forms by cyclization, especially in solution |
| Common assay method | HPLC with UV or RI detection | Separates creatine from creatinine and related impurities |
| Moisture content | Typically reported as percentage | Measured by Karl Fischer titration or loss on drying |
MT-ND6 is a gene of the mitochondrial genome coding for the NADH-ubiquinone oxidoreductase chain 6 protein (ND6). The ND6 protein is a subunit of NADH dehydrogenase (ubiquinone), which is located in the mitochondrial inner membrane and is the largest of the five complexes of the electron transport chain. Variations in the human MT-ND6 gene are associated with Leigh's syndrome, Leber's hereditary optic neuropathy (LHON) and dystonia.
People with Aarskog–Scott syndrome often have distinctive facial features, such as widely spaced eyes (hypertelorism), a small nose, a long area between the nose and mouth (philtrum), and a widow's peak hairline. They frequently have mild to moderate short stature during childhood, but their growth usually catches up with that of their peers during puberty. Hand abnormalities are common in this syndrome and include short fingers (brachydactyly), curved pinky fingers (fifth finger clinodactyly), webbing of the skin between some fingers (cutaneous syndactyly), and a single crease across the palm. Other abnormalities in people with Aarskog–Scott syndrome include heart defects and a split in the upper lip (cleft lip) with or without an opening in the roof of the mouth (cleft palate). Most males with Aarskog–Scott syndrome have a shawl scrotum, in which the scrotum surrounds the penis instead of hanging below. Less often, they have undescended testes (cryptorchidism) or a soft out-pouching around the belly-button (umbilical hernia) or in the lower abdomen (inguinal hernia). The intellectual development of people with Aarskog–Scott syndrome varies widely. Some may have mild learning and behavior problems, while others have normal intelligence. In rare cases, severe intellectual disability has been reported.
"Biosafety in Microbiological and Biomedical Laboratories", official CDC guide. "Prevention of Biological Hazards", EU-OSHA "Symbol Making", an account of the development of the symbol in 1966. "BioSeal Systems", Biosafety level 4 containment. Biohazard Remediation Compliance Overview "Example of Reclassified Biohazard to Level 4", article from The Lancet concerning the reclassification of Ebola after observation. "Biological hazards related to working alone safety", an article focusing on working alone safety when dealing with biological hazards
In some reactions, protons and hydroxide may directly act as acid and base in term of specific acid and specific base catalysis. But more often groups in substrate and active site act as Brønsted–Lowry acid and base. This is called general acid and general base theory. The easiest way to distinguish between them is to check whether the reaction rate is determined by the concentrations of the general acid and base. If the answer is yes then the reaction is the general type. Since most enzymes have an optimum pH of 6 to 7, the amino acids in the side chain usually have a pKa of 4~10. Candidate include aspartate, glutamate, histidine, cysteine. These acids and bases can stabilise the nucleophile or electrophile formed during the catalysis by providing positive and negative charges.
Sources: en.wikipedia.org
Tight junctions are very important in embryo development. In the blastula, these cadherin mediated cell interactions are essential to development of epithelium which are most important to paracellular transport, maintenance of cell polarity and the creation of a permeability seal to regulate blastocoel formation. These tight junctions arise after the polarity of epithelial cells is established which sets the foundation for further development and specification. Within the blastula, inner blastomeres are generally non-polar while epithelial cells demonstrate polarity. Mammalian embryos undergo compaction around the 8-cell stage where E-cadherins as well as alpha and beta catenins are expressed. This process makes a ball of embryonic cells which are capable of interacting, rather than a group of diffuse and undifferentiated cells. E-cadherin adhesion defines the apico-basal axis in the developing embryo and turns the embryo from an indistinct ball of cells to a more polarized phenotype which sets the stage for further development into a fully formed blastocyst. Xenopus membrane polarity is established with the first cell cleavage. Amphibian EP-cadherin and XB/U cadherin perform a similar role as E-cadherin in mammals establishing blastomere polarity and solidifying cell-cell interactions which are crucial for further development.
In 2001, Nakai et al. reported the development of GCaMP1 as a Ca2+ probe with improved signal-to-noise ratio compared to previously developed fluorescent Ca2+ probes. The first transgenic mouse expressing GCaMP1 was reported in 2004. However, at 37 ˚C (physiological temperature in mammals), GCaMP1 did not fold stably or fluoresce, limiting its potential use as a calcium indicator in vivo. In 2006, Tallini et al. subsequently reported the improvement of GCaMP1 to GCaMP2, which exhibited brighter fluorescence than GCaMP1 and greater stability at mammalian body temperatures. Tallini et al. expressed GCaMP2 in cardiomyocytes in mouse embryos to perform the first in vivo GCaMP imaging of Ca2+ in mammals. Further modifications of GCaMP, including GCaMP3, GCaMP5, GCaMP6, and jGCaMP7, have been developed to progressively improve the signal, sensitivity, and dynamic range of Ca2+ detection, with recent versions exhibiting fluorescence similar to native GFP.
CDs and DVDs have a protective film which must be stripped to reveal the gold reflective film or polycarbonate (PC) base. The surface of the disk can be activated to reveal the metal layer which allows compounds to bind to it. Compounds such as UV/ozone or an oxygen plasma treatment can be used to activate the disk to produce a hydrophilic surface with densely packed carboxylic acid groups. As one-off microassay can be printed onto the activated disks using a noncontact printer to dispel nanoliter quantities of coating conjugates onto the disk. Proteins or antibodies acting as probe molecules can then covalently bind to the disk surface and can be incubated. A polydimethylsiloxane (PDMS) channel plate can also be used to immobilize the probes in a line array. The plate is removed, and the process is repeated with another plate to deliver analyte samples in a line array perpendicular to the probe array. The probe and analyte samples can bind or hybridize at the intersections of the arrays to create rectangular hybridization sites. The disk is washed, rinsed, and dried prior to reading. This process can be done manually or automated; in theory discs with pre-made assays could be manufactured and sold en masse.
Sources: en.wikipedia.org
Biodiversity informatics deals with the collection and analysis of biodiversity data, such as taxonomic databases, or microbiome data. Examples of such analyses include phylogenetics, niche modelling, species richness mapping, DNA barcoding, or species identification tools. A growing area is also macro-ecology, i.e. the study of how biodiversity is connected to ecology and human impact, such as climate change. The enormous number of published literature makes it virtually impossible for individuals to read every paper, resulting in disjointed sub-fields of research. Literature analysis aims to employ computational and statistical linguistics to mine this growing library of text resources. For example: Abbreviation recognition – identify the long-form and abbreviation of biological terms Named-entity recognition – recognizing biological terms such as gene names Protein–protein interaction – identify which proteins interact with which proteins from text The area of research draws from statistics and computational linguistics.
Because their backbones are longer than those of normal peptides, β-peptides form disparate secondary structures. The alkyl substituents at both the α and β positions in a β-amino acid favor a gauche conformation about the bond between the α-carbon and β-carbon. This also affects the thermodynamic stability of the structure. Many types of helix structures consisting of β-peptides have been reported. These conformation types are distinguished by the number of atoms in the hydrogen-bonded ring that is formed in solution; 8-helix, 10-helix, 12-helix, 14-helix, and 10/12-helix have been reported. Generally speaking, β-peptides form a more stable helix than α-peptides. β-Peptides are stable against proteolytic degradation in vitro and in vivo, a potential advantage over natural peptides. β-Peptides have been used to mimic natural peptide-based antibiotics such as magainins, which are highly potent but difficult to use as drugs because they are degraded by proteolytic enzymes.
The AToFMS allows for the determination of mixing state, or distribution of chemical species, within individual particles. These mixing states are important in the determination of climate and health impact of aerosols. The schematic of a typical AToFMS is shown to the right. The overall structure of ATOF instruments is; sampling, sizing, and the mass analyzer region. The inlet system is similar to the AMS by using the same aerodynamic focusing lens, but it has smaller orifices because of its analysis of single particles. In the sizing region particle passes through the first continuous solid state laser that generates an initial pulse of scattered light. Then the particle passes through the second laser that is orthogonal to the first and produces a pulse of scattered light. The light is detected by a photomultiplier (PMT) that is matched up to each laser. Using the transit times between the two detected pulses and the fixed distance the velocity and size of each particle is calculated. Next the particles travel through to the mass analyzer region where it is ionized by a pulsed LDI laser, which is timed to hit the particle as it reaches the center of the ion extraction region. Once ionized, the positive ions are accelerated towards the positive ToF section and the negative ions are accelerated towards the negative ToF section where they are detected.
Sources: en.wikipedia.org
Dry, sealed creatine monohydrate can remain stable for years, but storage conditions affect its shelf life. Moisture, heat, and repeated opening of containers can reduce quality over time.
Creatine can lose a water molecule and cyclize into creatinine, especially in aqueous solution and at elevated temperatures. This is a chemical degradation process rather than microbial spoilage.
High-performance liquid chromatography is commonly used to quantify creatine and detect creatinine. Identity can be confirmed with spectroscopy or other instrumental methods.
Creatine is the base compound, while creatine monohydrate is a solid crystalline form that contains one water molecule per creatine molecule. Once dissolved, the monohydrate dissociates and releases creatine, which can participate in cellular energy metabolism. The monohydrate is the form most commonly used in research and commercial products.